Damp spots, it can occur quite easily and is difficult to deal with. There are several causes that cause damp patches to appear, but one of the common ones is penetrating damp. You can save yourself the expensive and time-consuming solutions by pre-treating the façade.

Moisture in the wall
Penetrating moisture is a major cause of moisture spots that do not show up on
ground level. In the case of penetrating moisture, the external walls absorb the
precipitation. Initially, the moisture spots are on the outside,
but after a while they can also become visible inside.

Moisture stains are something you don't want. As a result of moisture stains
This is because interior walls become damaged. Penetrating moisture also leads to
also lead to mould growth. Mould is not just 
bad for the wall, but also bad for your health. The moisture
also causes insulation material in the wall to become damp and therefore
less able to retain heat, which has a higher energy bill
as a result.

Addressing all these problems requires a lot of time and money. You can get ahead of all these problems by simply pre-treating the outer walls. However, it is important to pre-treat the exterior walls in the right way.

The solution
SUPER Impregnating agent by SuperCleaners Retail is the suitable product to prevent moisture in the wall. The product is a water-based professional impregnating agent. SUPER Impregnating Agent is suitable for impregnating both existing and new porous substrates, such as baked stone, concrete, sand-lime brick, plaster, natural stone and various other moisture-absorbing substrates.

The product is ideally suited to prevent moisture problems, frost damage, corrosion,
general soiling, growth of mould, moss and algae. The product guarantee of around 10 years
does prove that it is the perfect solution!

The steps
For a long-lasting waterproof result, follow these 6 steps:

1. Remove sand, clay and other loose particles from the substrate.
2. Before treatment, clean (degrease) the substrate with Super Degreaser or
   Super Industrial Cleaner
3. Assess the substrate for present moisture. Allow to dry thoroughly before applying the
   impregnate.
4. Take precautionary measures to avoid splashing on plastics, paving and glass.
5. In case of any spills, clean immediately with Super Degreaser or Super Industrial Cleaner.
6. Apply the product to the substrate using a flow or spray method at a temperature of at least 8 °C and dry weather. The impregnating agent must be well absorbed with a minimum consumption of 0.5 litres per square metre. If this differs, a second treatment should be carried out at all times.

SuperCleaners
SUPER Impregnating agent is a multifunctional maintenance and cleaning agent. The product page shows the various applications of the product. The SuperCleaners Retail range includes many more multifunctional maintenance and cleaning agents!